This is the Futaba 9CAP Super PCM Synthesized Computer Radio with the R319DPS 9 Channel 72MHz Receiver.
This version does not include servos.
This version has a ratcheted throttle and is configured for airplane use.

FEATURES:
No crystals required, simply move two rotary dials on transmitter and receiver to desired channel
Enhancements to all three modes over the original 9C series include; Glider Mode;
In addition to the Basic offset trim, three new offsets are offered (launch, thermal and speed) with camber that can be customized for each
Four camber mixes can be set up on one screen and programmed to any of the variable dials
Airplane Mode;
With either selectable switch using channels 5, 7 or 8 fliers can set up a two rate or a three rate GYA gyro system
Air brake is now switch-selectable
Helicopter Mode;
Throttle Curve and Pitch Curve now feature a delay for smoother transition from hover to idle-up and better control
Throttle Hold and Idle-Up can be assigned to any switch that feels more comfortable to the pilot
12 model memory expandable to 18 total with included CAMpac module All functions are assignable
3 function timer-up/down or to keep track of total flying time-and can be programmed to any of the switches, the power switch or the throttle stick
Full functionality trainer system, trainer cord not included
PCM or PPM switchable

Airplane Programmable Features; Heli Programmable Features;
7 usable programmable mixes plus
Aileron Differential
Airbrake (w/delayed elevator
Flaperon and Flap Trim
Elevator Flap Mix
V-Tail and ELEVON
4 Programmable Snap Rolls
Throttle-Needle Mixing
Twin Elevators Options
2nd Channel Aileron Select
Offset Mixing
Sailplane Programmable Features;
7 usable programmable mixes plus
Single/Dual Flap Servos
Flap Aileron/Aileron Flap
Elevator Flap
Aileron Differential
Butterfly Mixing
_ Start (Launch) Preset
Speed Preset
INCLUDES:
One 9CAP Super Synthesized Transmitter with module, neck strap and manual
R319DPS 9ch Synthesized Receiver, FUTL7610
One CamPac module
FBC-19B4 Wall Charger, FUTM1830
NT8S700B 700mAh Transmitter Battery, FUTM1460
ON/OFF Switch Harness, FUTM4385

REQUIRES:
Servos of modeler's choice
Receiver battery
SPECS:
Transmitter T9C Super:
Operating System: 2-Stick, 9-channel, PCM1024
Modulation: FM(PPM) or PCM, switchable
Power supply: 9.6V, NT8S700B
Current Drain: 280mA
Length: 2.56: (65mm)
Width: 1.42" (36mm)
Height: 0.85" (21.5mm)
Weight: 1.42 oz (40.3g)
FBC-19B4 Wall Charger:
Input: 120V AC 60Hz 7W
Output: Tx 9.6VDC 70mA
Rx 4.8VDC 100mA
R319DPS Receiver:
Length: 2.1" (53mm) Weight: 1.25 oz (35.4g)
Width: 1.3" (33mm) Power Requirement: 4.8V or 6V
Height: 0.8" (20mm)
COMMENTS:
The 9C Super differs from the standard 9C in that the Super's glider mode offers three offsets that can be customized, launch, thermal, and speed with camber. The four camber mixes can be set up on on screen and programmed to any of the variable dials. The Airplane Mode offers a selectable switch using channels 5, 7, and 8. All can be set up as a 2-rate (up or down) or a 3-rate (up/center/down) and a gyro gain menu. The Heli Mode offers throttle and pitch curve delay for smoother transition from hover to idle-up. The throttle hold and idle up can be assigned to any switch.